AIRBAG CUT-OFF SWITCH REMOVAL

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.


  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    Note


    • w/ Navigation System (for HDD):

      After the ignition switch is turned off, the HDD navigation system requires approximately a minute to record various types of memory and settings. As a result, after turning the ignition switch off, wait a minute or more before disconnecting the cable from the negative (-) battery terminal.

    • When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  2. REMOVE GLOVE COMPARTMENT DOOR ASSEMBLY

    A01IP4S

    1. Push in the sides of the glove compartment door to release the 2 stoppers and open the glove compartment door until it is horizontal.

    2. Detach the glove compartment door stopper from the glove compartment door as shown in the illustration.

    3. A01IP3S

      Pull the glove compartment door toward the rear of the vehicle to detach the 2 hinges and remove the glove compartment door.

  3. REMOVE AIRBAG CUTOFF SWITCH CYLINDER SUB-ASSEMBLY


    1. A01ISAM

      Detach the 2 claws and remove the cutoff switch cylinder.

    2. Disconnect the connector.