SIDE AIRBAG SENSOR REMOVAL

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.


  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    Note


    • w/ Navigation System (for HDD):

      After the ignition switch is turned off, the HDD navigation system requires approximately a minute to record various types of memory and settings. As a result, after turning the ignition switch off, wait a minute or more before disconnecting the cable from the negative (-) battery terminal.

    • When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  2. REMOVE FRONT DOOR SCUFF PLATE LH

    A01IPG9

    1. Detach the 8 claws and 2 clips, and remove the front door scuff plate.

  3. REMOVE REAR DOOR SCUFF PLATE LH

    A01IQ4G

    1. Detach the 9 claws and 2 clips, and remove the rear door scuff plate.

  4. REMOVE LOWER CENTER PILLAR GARNISH LH

    A01IUA8

    1. Detach the 2 claws and 2 clips, and remove the lower center pillar garnish.

  5. REMOVE SIDE AIRBAG SENSOR ASSEMBLY LH


    1. A01IRD6

      Disconnect the connector.

    2. Remove the bolt and side airbag sensor.