SIDE AIRBAG SENSOR REMOVAL

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.


  1. REMOVE BATTERY SERVICE HOLE COVER


    1. A01ITOM

      Remove the clip and battery service hole cover.

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    Note


    • w/ Navigation System (for HDD):

      After the ignition switch is turned off, the HDD navigation system requires approximately a minute to record various types of memory and settings. As a result, after turning the ignition switch off, wait a minute or more before disconnecting the cable from the negative (-) battery terminal.

    • When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  3. REMOVE FRONT DOOR SCUFF PLATE LH

    A01IPG9

    1. Detach the 8 claws and 2 clips, and remove the front door scuff plate.

  4. REMOVE REAR DOOR SCUFF PLATE LH

    A01IQ4G

    1. Detach the 9 claws and 2 clips, and remove the rear door scuff plate.

  5. REMOVE LOWER CENTER PILLAR GARNISH LH

    A01IUA8

    1. Detach the 2 claws and 2 clips, and remove the lower center pillar garnish.

  6. REMOVE SIDE AIRBAG SENSOR ASSEMBLY LH


    1. A01IRD6

      Disconnect the connector.

    2. Remove the bolt and side airbag sensor.