SPIRAL CABLE

Click here

Click here Click here

Tip:

Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.

Click here

Click here
INSTALL SPIRAL CABLE SUB-ASSEMBLY
1. Attach the 3 claws to install the spiral cable.
  
  CAUTION:
  
  When replacing the spiral cable with a new one, remove the lock pin before installing the steering wheel assembly.
2. Connect the connectors to the spiral cable.
  
  Note:
  When handling the airbag connector, take care not to damage the airbag wire harness.
Click here
INSTALL UPPER STEERING COLUMN COVER

Note:
If the steering column cover is installed in an incorrect order, it will not be possible to assemble the steering column cover.
1. Attach the claw and 2 pins to install the upper steering column cover.
Click here
INSTALL LOWER STEERING COLUMN COVER
1. Attach the 2 claws and install the steering column lower cover as shown in the illustration.
2. Attach the 4 claws.
3. Attach the claw.
  
  Tip:
  Press the area around the claw to attach it.
Click here
ADJUST SPIRAL CABLE SUB-ASSEMBLY
1. Turn the ignition switch off.
2. Disconnect the cable from the negative (-) battery terminal.
  
  CAUTION:
  
  Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
3. Rotate the spiral cable counterclockwise slowly by hand until it feels firm.
  
  CAUTION:
  
  Do not turn the spiral cable by the airbag wire harness.
4. Rotate the spiral cable clockwise approximately 2.5 turns to align the marks.
  
  CAUTION:
  
  Do not turn the spiral cable by the airbag wire harness.
  
  Tip:
  The spiral cable can be rotated approximately 2.5 turns to both the left and right from the center.
Click here
INSTALL STEERING WHEEL ASSEMBLY
1. Install the steering wheel assembly (Click here).

SPIRAL CABLE INSTALLATION