CHECK COMBINATION METER ASSEMBLY
Measure the resistance and voltage according to the value(s) in the table below.
| Terminal No. (Symbol) | Wiring Color | Terminal Description | Condition | Specified Condition |
|---|---|---|---|---|
| H62-3 (+S) - Body ground | Y - Body ground | Speed signal (output) | Vehicle being driven approximately 20 km/h (12 mph) | Pulse generation (See waveform 1) |
| H62-5 (SI) - Body ground | V - Body ground | Speed signal (input) | Vehicle being driven approximately 20 km/h (12 mph) | Pulse generation (See waveform 1) |
| H62-7 (TC) - Body ground | R - Body ground | Light control rheostat signal | Light control rheostat pushed | Below 1 V |
| Light control rheostat not pushed | 11 to 14 V | |||
| H62-10 (SW) - Body ground | SB - Body ground | Brake fluid level warning light signal | Ignition switch ON, brake system warning light (red indicator) on | Below 1 V |
| Ignition switch ON, brake system warning light (red indicator) off | 11 to 14 V | |||
| H62-11 (PKB1) - Body ground | L - Body ground | Passenger side seat belt condition signal | Ignition switch ON, front passenger side seat belt warning light off | 11 to 14 V |
| Ignition switch ON, front passenger side seat belt warning light on | Below 1 V | |||
| H62-12 (LVWG) - Body ground*6 | GR - Body ground | LEVELING indicator light signal | Ignition switch ON, headlight dimmer switch set to head | Below 1 V |
| Ignition switch ON, headlight dimmer switch not set to head | 11 to 14 V | |||
| H62-13 (MSD) - Body ground*1 | R - Body ground | Rear seat 3 point type inner belt assembly LH | Rear seat inner belt LH unfastened | Below 1 V |
| Rear seat inner belt LH fastened | 11 to 14 V | |||
| H62-14 (MSTI) - Body ground*1 | W - Body ground | Rear seat inner belt assembly (for LH Side) | Rear seat center belt unfastened | Below 1 V |
| Rear seat center belt fastened | 11 to 14 V | |||
| H62-15 (MSFM) - Body ground*1 | B - Body ground | Rear seat 3 point type inner belt assembly RH | Rear seat inner belt RH unfastened | Below 1 V |
| Rear seat inner belt RH fastened | 11 to 14 V | |||
| H62-16 (OILW) - Body ground*2 | G - Body ground | Engine oil level signal | Ignition switch ON, ENGINE OIL LOW displayed | Below 1 V |
| Ignition switch ON, ENGINE OIL LOW not displayed | 11 to 14 V | |||
| H62-17 (S) - Body ground | Y - Body ground | Engine oil pressure signal | Ignition switch ON, ENGINE OIL PRESSURE LOW displayed | Below 1 V |
| Ignition switch ON, ENGINE OIL PRESSURE LOW not displayed | 11 to 14 V | |||
| H62-19 (B) - Body ground | L - Body ground | Turn signal R | Ignition switch ON, turn signal switch neutral position | Below 1 V |
| Ignition switch ON, turn signal switch turned to right | Alternating between below 1 and 11 to 14 V | |||
| H62-20 (B) - Body ground | Y - Body ground | Turn signal L | Ignition switch ON, turn signal switch neutral position | Below 1 V |
| Ignition switch ON, turn signal switch turned to left | Alternating between below 1 and 11 to 14 V | |||
| H62-21 (ET) - Body ground | BR - Body ground | Ground | Always | Below 1 V |
| H62-22 (CANH) - Body ground | SB - Body ground | CAN communication signal | Ignition switch off | 200 Ω or higher |
| H62-23 (CANL) - Body ground | W - Body ground | CAN communication signal | Ignition switch off | 200 Ω or higher |
| H62-24 (E) - Body ground | BR - Body ground | Fuel sender gauge ground | Always | Below 1 Ω |
| H62-25 (TX1+) - Body ground | L - Body ground | Cooler thermistor (ambient temperature sensor) ground | Always | Below 1 Ω |
| H62-26 (E1) - Body ground | B - Body ground | Light control rheostat ground | Always | Below 1 Ω |
| H62-28 (S) - Body ground*2, *7 | R - Body ground | Fuel sedimenter signal | Ignition switch ON, DRAIN WATER FROM FUEL FILTER displayed | Below 1 V |
| Ignition switch ON, DRAIN WATER FROM FUEL FILTER not displayed | 11 to 14 V | |||
| H62-29 (EFI) - Body ground | P - Body ground | MIL (check engine indicator light) signal | Ignition switch ON, MIL on | Below 1 V |
| Ignition switch ON, MIL off | 11 to 14 V | |||
| H62-30 (CHG-) - Body ground | Y - Body ground | CHARGE warning light | Ignition switch ON, CHARGE warning light on | Below 1 V |
| Ignition switch ON, CHARGE warning light off | 11 to 14 V | |||
| H62-32 (SW1) - Body ground | B - Body ground | Spiral cable signal | Ignition switch ON, steering pad DISP switch signal off | Below 1 V |
| Ignition switch ON, steering pad DISP switch signal on | 11 to 14 V | |||
| H62-33 (TEMP) - Body ground | W - Body ground | Cooler thermistor (ambient temperature sensor) signal | Outside temperature 25°C (77°F) | 1.6 to 1.8 Ω*4 |
| H62-34 (MSM+) - Body ground*3 | G - Body ground | Rear No. 2 seat belt sub-assembly | Rear No. 2 seat belt unfastened | Below 1 V |
| Rear No. 2 seat belt fastened | 11 to 14 V | |||
| H62-35 (MS+) - Body ground*3 | L - Body ground | Rear No. 2 seat belt sub-assembly | Rear No. 2 seat belt unfastened | Below 1 V |
| Rear No. 2 seat belt fastened | 11 to 14 V | |||
| H62-36 (TIRE) - Body ground*5 | V - Body ground | Tire pressure warning light signal | Ignition switch ON, tire pressure warning light off | 3.2 V or higher |
| Ignition switch ON, tire pressure warning light on | 0.9 to 3.2 V | |||
| H62-37 (L) - Body ground | Y - Body ground | Fuel sender gauge signal | Fuel F (full tank) to E (empty) | 4.5 to 9 V |
| H62-39 (IG+) - Body ground | P - Body ground | Ignition switch signal | Ignition switch off | Below 1 V |
| Ignition switch ON | 11 to 14 V | |||
| H62-40 (B) - Body ground | W - Body ground | Battery | Always | 11 to 14 V |
*1: w/ Rear No. 1 Seat
*2: for AD Series Engine
*3: w/ Rear No. 2 Seat
*4: The standard value changes according to the outside temperature.
*5: w/ Tire Pressure Warning System
*6: w/ HID Headlight System
*7: for 1WW
Using an oscilloscope, check waveform 1.
| Item | Condition |
|---|---|
| Terminal No. (Symbol) |
|
| Tool setting | 5 V/DIV., 20 ms./DIV. |
| Condition | Being driven at approximately 20 km/h (12 mph) |
When the system is functioning normally, one wheel revolution generates 4 pulses. As the vehicle speed increases, the width indicated by (A) in the illustration narrows.
CHECK COMBINATION METER ASSEMBLY INNER CIRCUIT
*1: w/ Rear No. 1 Seat
*2: w/ Rear No. 2 Seat
*3: for LHD
*4: for RHD
*5: for AD Series Engine
*6: w/ Cruise Control System
*7: except Manual Transaxle
*8: w/ HID Headlight System
*9: except CVT
*10: w/ Rear Fog Light
*11: w/ Front Fog Light
*12: w/ Tire Pressure Warning System
*13: w/ Stop and Start System
*14: w/o Stop and Start System
*15: Engine Type Diesel
*16: except 1WW
*17: for 1WW
| Terminal No. | Wire Harness Side | |
|---|---|---|
| H62 | 1 | - |
| 2 | - | |
| 3 | Each part that uses the vehicle speed signal | |
| 4 | - | |
| 5 | Brake actuator assembly | |
| 6 | - | |
| 7 | Light control rheostat | |
| 8 | - | |
| 9 | - | |
| 10 | Brake fluid level warning switch | |
| 11 | Occupant detection switch | |
| 12*1 | Headlight leveling ECU assembly | |
| 13*2 | Rear seat 3 point type inner belt assembly LH | |
| 14*2 | Rear seat inner belt assembly (for LH Side) | |
| 15*2 | Rear seat 3 point type inner belt assembly RH | |
| 16*3 | Engine oil level sensor | |
| 17 | Engine oil pressure switch assembly | |
| 18 | - | |
| 19 | Turn signal flasher assembly | |
| 20 | Turn signal flasher assembly | |
| 21 | Ground | |
| 22 | CAN communication line | |
| 23 | CAN communication line | |
| 24 | Fuel sender gauge assembly | |
| 25 | Cooler thermistor (ambient temperature sensor) | |
| 26 | Light control rheostat | |
| 27 | - | |
| 28*3, *8 | Level warning switch | |
| 29 | ECM | |
| 30 | Generator | |
| 31 | - | |
| 32 | Steering pad switch assembly | |
| 33 | Cooler thermistor (ambient temperature sensor) | |
| 34*4 | Rear No. 2 seat belt sub-assembly | |
| 35*4 | Rear No. 2 seat belt sub-assembly | |
| 36*5 | Tire pressure warning ECU and receiver | |
| 37 | Fuel sender gauge assembly | |
| 38 | - | |
| 39 |
|
|
| 40 | Battery | |
*1: w/ HID Headlight System
*2: w/ Rear No. 1 Seat
*3: for AD Series Engine
*4: w/ Rear No. 2 Seat
*5: w/ Tire Pressure Warning System
*6: w/ Stop and Start System
*7: w/o Stop and Start System
*8: for 1WW