ROOM LIGHT (for Front) INSPECTION


  1. INSPECT MAP LIGHT ASSEMBLY

    A01ITZEE01
    Text in Illustration
    *a

    Component without harness connected

    (Map Light Assembly)

    1. Check the resistance.


      1. Measure the resistance according to the value(s) in the table below.

        Standard Resistance
        Tester Connection Switch Condition Specified Condition
        7 (+B1) - 2 (GND) Spot light switch off 10 kΩ or higher
        Spot light switch on Below 1 Ω
        7 (+B1) - 6 (CTY) Not door position 10 kΩ or higher
        Door position Below 1 Ω

        If the result is not as specified, replace the map light assembly.