BACK DOOR LOCK INSTALLATION

Note


  • When installing a new back door lock assembly, if there is any tape stuck to it, remove the tape.

  • When installing a new back door lock assembly, if there are any strings attached to it, cut the strings off.


  1. INSTALL BACK DOOR LOCK ASSEMBLY


    1. A01IQJ0

      Connect the connector.

    2. Install the back door lock assembly with the 3 bolts.

      Torque:
      7.5 N*m  { 76 kgf*cm, 66 in.*lbf }

  2. INSTALL BACK DOOR TRIM PANEL ASSEMBLY


    1. A01IPJU

      Attach the 12 clips to install the back door trim.

    2. A01ITD9

      Attach the clip.

  3. INSTALL BACK DOOR INSIDE HANDLE


    1. A01IN27

      Attach the 4 claws to install the door inside handle.

  4. INSTALL BACK DOOR SIDE GARNISH RH


    1. A01IOOI

      Attach the 2 clips and claw to install the back door side garnish.

  5. INSTALL BACK DOOR SIDE GARNISH LH


    1. A01IUHF

      Attach the 2 clips and claw to install the back door side garnish.

  6. INSTALL CENTER BACK DOOR GARNISH


    1. A01IOP0

      Attach the 4 claws and 4 clips to install the center back door garnish.