TRANSMITTER BATTERY (w/o Entry and Start System) REPLACEMENT

Note

Take extra care when handling these precision electronic components.


  1. REMOVE TRANSMITTER HOUSING COVER


    1. A01IOPEE01
      Text in Illustration
      *1 Protective Tape

      Twist a screwdriver in the direction of the arrow in the illustration, and remove the transmitter housing cover.

      Note

      Do not forcibly pry open the cover.

      Tech Tips

      Tape the screwdriver tip before use.

  2. REMOVE DOOR CONTROL TRANSMITTER MODULE


    1. A01ITX4E01
      Text in Illustration
      *1 Protective Tape

      Using a precision screwdriver, remove the door control transmitter module.

      Note

      When replacing the transmitter battery, before starting work, remove static electricity that has built up in the body by touching, for example, the vehicle to prevent the door control transmitter module set from being damaged.

      Tech Tips

      Tape the screwdriver tip before use.

  3. REMOVE TRANSMITTER BATTERY


    1. A01INF0

      Twist a coin in the direction of the arrow in the illustration and remove the transmitter battery cover.

      Note

      When replacing the transmitter battery, before starting work, remove static electricity that has built up in the body by touching, for example, the vehicle to prevent the door control transmitter module set from being damaged.

    2. A01IU0R

      Remove the battery (lithium battery: CR2016).

      Note


      • When replacing the transmitter battery, before starting work, remove static electricity that has built up in the body by touching, for example, the vehicle to prevent the door control transmitter module set from being damaged.

      • Do not push the terminals with your finger.

      • Do not forcibly pry up the battery. The terminals may become damaged.

      • Do not touch the battery with wet hands. Water may cause rust.

      • Do not touch or move any components inside the transmitter. It may cease to work.

  4. INSTALL TRANSMITTER BATTERY


    1. A01IN0J

      Install a new battery (lithium battery: CR2016) with the positive (+) side facing upward as shown in the illustration.

      Note


      • Be careful not to bend the transmitter battery electrode during insertion.

      • Keep the transmitter cover interior free of dust and oil.

    2. A01IP1W

      Install the cover.

  5. INSTALL DOOR CONTROL TRANSMITTER MODULE

    A01IRKU

    1. Install the door control transmitter module.

  6. INSTALL TRANSMITTER HOUSING COVER


    1. A01IS0Q

      Install the transmitter housing cover to the transmitter housing case.

    2. Check that the transmitter LED illuminates 3 times when a switch is pressed 3 times.