KEY REMINDER WARNING SYSTEM Key Reminder Buzzer does not Sound

DESCRIPTION

The key reminder warning buzzer sounds when the driver side door is opened while the ignition switch is ACC, or while the ignition switch is off and the key is in the ignition key cylinder. The key reminder warning buzzer is activated when the main body ECU sends an unlock warning switch signal and front door courtesy light switch LH*1 or RH*2 signal to the combination meter.


Tech Tips

Since the key reminder warning system has functions that use CAN communication, first confirm that there is no malfunction in the communication system by inspecting CAN communication in accordance with the "How to Proceed with Troubleshooting" procedures. Then, conduct the following inspection procedure.

WIRING DIAGRAM

A01IPEWE03

INSPECTION PROCEDURE

PROCEDURE


  1. READ VALUE USING INTELLIGENT TESTER (FRONT DOOR COURTESY LIGHT SWITCH)


    • *1: for LHD

    • *2: for RHD


    1. Check the Data List for proper functioning of the front door courtesy light switch LH*1 or RH*2.

      Main Body
      Tester Display Measurement Item/Range Normal Condition Diagnostic Note
      D Door Courtesy SW Front door courtesy light switch LH*1 or RH*2 signal / ON or OFF

      ON: Driver side door open

      OFF: Driver side door closed

      		 -
      OK
      ON (driver door is open) appears on the screen.

    NG

    GO TO LIGHTING SYSTEM Click here

    OK

  2. READ VALUE USING INTELLIGENT TESTER (UNLOCK WARNING SWITCH)


    1. Check the Data List for proper functioning of the unlock warning switch.

      Main Body
      Tester Display Measurement Item/Range Normal Condition Diagnostic Note
      Key Unlock Warning SW Unlock warning switch signal / ON or OFF

      ON: Key in ignition key cylinder

      OFF: No key in ignition key cylinder

      		 -
      OK
      ON (key is in ignition key cylinder) appears on the screen.

    NG

    INSPECT UNLOCK WARNING SWITCH ASSEMBLY Click here

    OK

    REPLACE MAIN BODY ECU (INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY)

  3. INSPECT UNLOCK WARNING SWITCH ASSEMBLY

    A01IN1IE06

    1. Remove the unlock warning switch Click here.

    2. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Switch Condition Specified Condition
      1 - 2 Not pushed 10 kΩ or higher
      Pushed Below 1 Ω

    NG

    REPLACE UNLOCK WARNING SWITCH ASSEMBLY Click here

    OK

  4. CHECK HARNESS AND CONNECTOR (UNLOCK WARNING SWITCH - MAIN BODY ECU AND BODY GROUND)

    A01IU9JE05
    Text in Illustration
    *1

    Front view of wire harness connector

    (to Unlock Warning Switch)
    *2

    Front view of wire harness connector

    (to Main Body ECU)

    1. Disconnect the H7 switch connector.

    2. Disconnect the DE ECU connector.

    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      H7-1 - DE-23 (KSW) Always Below 1 Ω
      H7-2 - Body ground Always Below 1 Ω
      DE-23 (KSW) - Body ground Always 10 kΩ or higher

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR

    OK

  5. CHECK COMBINATION METER ASSEMBLY (OPERATION)


    1. Temporarily replace the combination meter assembly with a new or normally functioning one Click here.

    2. Check the key reminder warning system Click here.

      OK
      The key reminder warning system functions properly.

    NG

    REPLACE MAIN BODY ECU (INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY)

    OK

    END (COMBINATION METER IS DEFECTIVE)