WIRELESS DOOR LOCK CONTROL SYSTEM (w/ Entry and Start System) HOW TO PROCEED WITH TROUBLESHOOTING

Tech Tips


  • The wireless door lock control system troubleshooting procedures are based on the premise that the power door lock control systems is operating normally. Check the power door lock control system first before troubleshooting the wireless door lock control system.

  • Use these procedures to troubleshoot the wireless door lock control system.

  • *: Use the intelligent tester.


  1. VEHICLE BROUGHT TO WORKSHOP


    NEXT
  2. INSPECT BATTERY VOLTAGE

    Standard voltage
    11 to 14 V

    If the voltage is below 11 V, recharge or replace the battery before proceeding.


    NEXT
  3. CHECK FOR DTC*


    1. Check for DTCs and note any codes that are output Click here.

    2. Clear the DTCs Click here.

    3. Recheck for DTCs Click here. Based on the DTCs output above, try to force output of the same CAN communication system DTC or wireless door lock control system DTC by reproducing the symptoms indicated by the DTC.

      Result
      Result Proceed to
      DTC is not output A
      CAN communication system DTC is output B
      Wireless door lock control system DTC is output C

      B
      C
      A
  4. PROBLEM SYMPTOMS TABLE


    1. Refer to Problem Symptoms Table Click here.

      Result
      Result Proceed to
      Fault is not listed in problem symptoms table A
      Fault is listed in problem symptoms table B

      B
      A
  5. OVERALL ANALYSIS AND TROUBLESHOOTING*


    1. Operation Check Click here

    2. Terminals of ECU Click here

    3. Data List / Active Test Click here


      NEXT
  6. REPAIR OR REPLACE


    NEXT
  7. CONFIRMATION TEST


    NEXT