Click here

LIN COMMUNICATION SYSTEM Rain Sensor LIN Communication Malfunction

Click here
Click here Click here
DTC Code DTC Name
  Rain Sensor LIN Communication Malfunction
Click here

DESCRIPTION

The LIN communication of the components related to the rain sensor occurs between the rain sensor and windshield wiper relay.

Click here

WIRING DIAGRAM

Click here

INSPECTION PROCEDURE

Note:

  • When using the intelligent tester with the ignition switch off to troubleshoot:

    Connect the intelligent tester to the vehicle, and turn a courtesy light switch on and off at 1.5 second intervals until communication between the intelligent tester and vehicle begins.

  • Inspect the fuses and bulbs for circuits related to this system before performing the following inspection procedure.

Click here

PROCEDURE


  1. Click here

    CHECK HARNESS AND CONNECTOR (RAIN SENSOR - WINDSHIELD WIPER RELAY)


    1. A01IQ09E01

      Disconnect the H56 relay connector.

    2. Disconnect the Q5 sensor connector.

    3. Measure the resistance and voltage according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      Q5-1 (MPX) - H56-14 (SPD) Always Below 1 Ω
      Q5-3 (SIG) - H56-13 (SIG) Always Below 1 Ω
      Q5-2 (ES) - H56-7 (ES) Always Below 1 Ω
      Q5-1 (MPX) - Body ground Always 10 kΩ or higher
      Q5-3 (SIG) - Body ground Always 10 kΩ or higher
      Q5-2 (ES) - Body ground Always 10 kΩ or higher
      H56-12 (E) - Body ground Always Below 1 Ω
      Standard Voltage
      Tester Connection Switch Condition Specified Condition
      H56-2 (IG) - Body ground Ignition switch ON 11 to 14 V
      Table 1. Text in Illustration
      *1

      Front view of wire harness connector

      (to Windshield Wiper Relay)
      *2

      Front view of wire harness connector

      (to Rain Sensor)

  2. Click here

    CHECK WINDSHIELD WIPER RELAY ASSEMBLY


    1. Connect the H56 relay connector.

    2. Measure the voltage according to the value(s) in the table below.

      Standard Voltage
      Tester Connection Switch Condition Specified Condition
      H56-13 (SIG) - H56-7 (ES) Ignition switch ON 11 to 14 V
      Table 2. Text in Illustration
      *1

      Component with harness connected

      (Windshield Wiper Relay)
      Table 3. Result
      Result Proceed to
      OK A
      NG (for LHD) B
      NG (for RHD) C

  3. Click here

    REPLACE RAIN SENSOR


    1. Temporarily replace the rain sensor with a new one (Click here).

    2. Check that the rain sensor function is normal.

      OK
      Rain sensor function is normal.
      Table 4. Result
      Result Proceed to
      OK A
      NG (for LHD) B
      NG (for RHD) C

  4. Click here

    REPAIR OR REPLACE HARNESS OR CONNECTOR

  5. Click here

    REPLACE WINDSHIELD WIPER RELAY ASSEMBLYClick here

  6. Click here

    END (RAIN SENSOR IS DEFECTIVE)

  7. Click here

    REPLACE WINDSHIELD WIPER RELAY ASSEMBLYClick here