POWER MANAGEMENT CONTROL ECU (for RHD) REMOVAL


  1. REMOVE INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY


    1. Remove the instrument panel safety pad Click here.

  2. REMOVE GLOVE COMPARTMENT DOOR ASSEMBLY

    A01IP4S

    1. Push in the sides of the glove compartment door to release the 2 stoppers and open the glove compartment door until it is horizontal.

    2. Detach the glove compartment door stopper from the glove compartment door as shown in the illustration.

    3. A01IP3S

      Pull the glove compartment door toward the rear of the vehicle to detach the 2 hinges and remove the glove compartment door.

  3. REMOVE FRONT DOOR SCUFF PLATE LH

    A01IPG9

    1. Detach the 8 claws and 2 clips, and remove the front door scuff plate.

  4. REMOVE COWL SIDE TRIM BOARD LH

    A01ISRD

    1. Detach the 2 clips and guide, and remove the cowl side trim board.

  5. REMOVE CONNECTOR HOLDER


    1. A01IPYZ

      Detach the 2 clamps.

    2. Remove the bolt and connector holder.

  6. REMOVE POWER MANAGEMENT CONTROL ECU

    A01IOMZE01

    1. Disconnect the 2 connectors.

    2. Remove the 2 bolts and power management control ECU.