GENERATOR INSPECTION


  1. INSPECT GENERATOR PULLEY WITH CLUTCH


    1. A01ISGG

      Hold the center of the generator pulley with clutch, and confirm that the outer ring turns counterclockwise and does not turn clockwise.

      Text in Illustration
      A01ISM9 Free
      A01ISER Lock

      If the result is not as specified, replace the generator pulley with clutch.

  2. INSPECT GENERATOR BRUSH HOLDER ASSEMBLY


    1. A01IMZGE06
      Text in Illustration
      *1 Length

      Using a vernier caliper, measure the brush length.

      Standard exposed length
      9.5 to 11.5 mm (0.374 to 0.453 in.)
      Minimum exposed length
      4.5 mm (0.177 in.)

      If the brush length is less than the minimum, replace the generator brush holder assembly.

  3. INSPECT GENERATOR ROTOR ASSEMBLY


    1. Check the resistance.


      1. A01IR7YE21
        Text in Illustration
        *1 Slip Ring

        Measure the resistance according to the value(s) in the table below.

        Standard Resistance
        Tester Connection Condition Specified Condition
        Slip ring - Slip ring 20°C (68°F) 1.8 to 2.2 Ω

        If the result is not as specified, replace the generator rotor assembly.

      2. A01IU93E16
        Text in Illustration
        *1 Slip Ring
        *2 Rotor

        Measure the resistance according to the value(s) in the table below.

        Standard Resistance
        Tester Connection Condition Specified Condition
        Slip ring - Rotor Always 10 MΩ or higher

        If the result is not as specified, replace the generator rotor assembly.

    2. A01ISA3

      Check that the bearing of the generator rotor is not rough or worn and that it rotates smoothly.

      If necessary, replace the generator rotor assembly.

    3. Check each slip ring.


      1. Check that the slip rings are not rough or scored.

        If the slip rings are rough or scored, replace the generator rotor assembly.

      2. A01IN7WE01
        Text in Illustration
        *1 Diameter

        Using a vernier caliper, measure the slip ring diameter.

        Standard diameter
        14.2 to 14.8 mm (0.559 to 0.583 in.)
        Minimum diameter
        14.0 mm (0.551 in.)

        If the diameter is less than the minimum, replace the generator rotor assembly.