Click here

GENERATOR REMOVAL

Click here
Click here Click here
  1. Click here

    PRECAUTION

    Note:

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).

  2. Click here

    DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).

  3. Click here

    REMOVE NO. 1 ENGINE COVER


    1. A01IRDDE01

      Lift the No. 1 engine cover to detach the 4 clips in the order shown in the illustration and remove the No. 1 engine cover.

      Note:

      Attempting to disengage both front and rear clips at the same time may cause the No. 1 engine cover to break.

  4. Click here

    REMOVE RADIATOR SUPPORT OPENING COVER


    1. A01IPK0

      Remove the 3 clips.

    2. Detach the 4 hooks and remove the radiator support opening cover.

  5. Click here

    REMOVE NO. 1 ENGINE UNDER COVER


    1. A01IR30

      Remove the 6 bolts and 11 clips.

    2. Remove the No. 1 engine under cover.

  6. Click here

    REMOVE REAR ENGINE UNDER COVER RH


    1. Remove the 5 clips and rear engine under cover RH.

  7. Click here

    REMOVE FRONT SUSPENSION MEMBER REINFORCEMENT RH


    1. A01IQDX

      Remove the 4 bolts and front suspension member reinforcement RH.

  8. Click here

    REMOVE FAN AND GENERATOR V BELT


    1. A01IO52E01

      Rotate the pulley of the V-ribbed belt tensioner assembly clockwise to loosen the fan and generator V belt and reduce the tension. Then remove the fan and generator V belt.

      Table 1. Text in Illustration
      *A w/ Air Conditioning System
      *B w/o Air Conditioning System
  9. Click here

    REMOVE GENERATOR ASSEMBLY


    1. A01IOUH

      Disconnect the generator connector.

    2. Remove the terminal cap.

    3. Remove the nut and disconnect the generator wire.

    4. A01IO8LE01

      Using an E12 "TORX" socket wrench, remove the 2 bolts as shown in the illustration.

      Tip:

      Bolt A cannot be removed with the generator assembly installed to the vehicle.

    5. A01IPFB

      Remove the generator assembly as shown in the illustration.