GENERATOR REMOVAL


  1. REMOVE RADIATOR SUPPORT OPENING COVER


    1. A01IQMS

      Remove the 3 clips.

    2. Detach the 4 hooks and remove the radiator support opening cover.

  2. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

  3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  4. REMOVE REAR ENGINE UNDER COVER RH


    1. A01IP88

      Remove the 5 clips and under cover RH.

  5. REMOVE NO. 2 CYLINDER HEAD COVER


    1. A01IRS7

      Hold the rear of the cover and raise it to detach the 2 clips on the rear of the cover. Continue to raise the cover to detach the 2 clips on the front of the cover and remove the cover.

      Note

      Attempting to detach both front and rear clips at the same time may cause the cover to break.

  6. REMOVE V-RIBBED BELT


    1. A01ITH6E01

      Loosen bolts A and B.

    2. Loosen bolt C and remove the V-ribbed belt.

      Note

      Do not loosen bolt D.

  7. REMOVE GENERATOR ASSEMBLY


    1. A01IUOO

      Remove the terminal cap.

    2. Remove the nut and disconnect the wire harness from terminal B.

    3. Disconnect the connector and detach the wire harness clamp.

    4. A01IO51E01

      Remove the 2 bolts and adjusting bar.

    5. A01IO9BE01

      Remove the bolt and generator assembly.

    6. A01IQ3U

      Remove the bolt and wire harness clamp bracket.