GENERATOR (for 130 A Type) REMOVAL


  1. REMOVE FRONT DRIVE SHAFT ASSEMBLY RH


    1. Remove the front drive shaft assembly RH Click here.

  2. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

  3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  4. REMOVE NO. 1 ENGINE COVER


    1. A01INMI

      Hold the rear of the No. 1 engine cover and slowly raise it to detach the clip on the rear of the No. 1 engine cover. Continue to raise the No. 1 engine cover to detach the 3 clips on the front and side of the No. 1 engine cover and remove the No. 1 engine cover.

      Note

      Attempting to disengage both front and rear clips at the same time may cause the No. 1 engine cover to break.

  5. REMOVE RADIATOR SUPPORT OPENING COVER


    1. A01IS0M

      Remove the 3 clips.

    2. Detach the 4 hooks and remove the radiator support opening cover.

  6. REMOVE NO. 1 ENGINE UNDER COVER


    1. A01IRQL

      Remove the 6 bolts and 10 clips.

    2. Remove the No. 1 engine under cover.

  7. REMOVE REAR ENGINE UNDER COVER RH


    1. A01IQ51

      Remove the 5 clips and rear engine under cover RH.

  8. REMOVE FRONT SUSPENSION MEMBER REINFORCEMENT RH


    1. A01INC5

      Remove the 4 bolts and front suspension member reinforcement RH.

  9. REMOVE FAN AND GENERATOR V BELT


    1. Using SST and a 22 mm wrench, rotate the V-ribbed belt tensioner pulley counterclockwise to loosen the fan and generator V belt tension. Then remove the fan and generator V belt.

      SST
      09216-42010

      CAUTION:


      • Be careful as the wrench only fits loosely on the belt tensioner tool set point. The wrench may come off the set point and cause injuries.

      • Be careful that your hands do not become jammed between parts such as the fan and generator V belt, pulleys, etc.

      Note

      Make sure SST is installed as shown in the illustration. If not, SST and/or the fan and generator V belt may not be able to be removed.

      A01ISZME02
      Text in Illustration
      *A w/o Air Conditioning System *B w/ Air Conditioning System

  10. REMOVE GENERATOR ASSEMBLY


    1. A01IN5D

      Remove the terminal cap.

    2. Disconnect the generator connector and detach the clamp.

    3. Remove the nut and bolt, and disconnect the generator wire.

    4. A01ISLO

      Remove the 3 bolts and generator assembly.