GENERATOR (for 130 A Type) INSTALLATION


  1. INSTALL GENERATOR ASSEMBLY


    1. A01ISLO

      Install the generator assembly with the 3 bolts.

      Torque:
      25 N*m  { 255 kgf*cm, 18 ft.*lbf }

      Note

      Make sure that the wire harness of the crankshaft position sensor does not get caught between the cylinder block and generator when installing the generator.

    2. Attach the wire clamp.

    3. A01IN5D

      Connect the generator wire with the nut and bolt.

      Torque:
      for nut
      9.8 N*m  { 100 kgf*cm, 87 in.*lbf }
      for bolt
      8.4 N*m  { 85 kgf*cm, 74 in.*lbf }

    4. Connect the generator connector and attach the clamp.

    5. Install the terminal cap.

  2. INSTALL FAN AND GENERATOR V BELT


    1. Using SST and a 22 mm wrench, rotate the tensioner pulley counterclockwise, and then install the fan and generator V belt.

      SST
      09216-42010

      CAUTION:


      • Be careful as the wrench only fits loosely on the belt tensioner tool set point. The wrench may come off the set point and cause injuries.

      • Be careful that your hands do not become jammed between parts such as the belt, pulleys, etc.

      Note


      • Make sure that the belt is set properly on each pulley.

      • Make sure SST is installed as shown in the illustration. If not, SST and/or the belt may not be able to be removed.

      A01ISZME01

  3. INSTALL FRONT SUSPENSION MEMBER REINFORCEMENT RH


    1. A01INC5E01

      Install the front suspension member reinforcement RH with the 4 bolts.

      Torque:
      99 N*m  { 1010 kgf*cm, 73 ft.*lbf }

      Note

      Tighten the bolts in the order shown in the illustration.

  4. INSTALL REAR ENGINE UNDER COVER RH


    1. Install the rear engine under cover RH with the 5 clips.

  5. INSTALL NO. 1 ENGINE UNDER COVER


    1. A01IRQL

      Remove the 6 bolts and 10 clips.

    2. Remove the No. 1 engine under cover.

  6. INSTALL RADIATOR SUPPORT OPENING COVER


    1. Attach the 4 hooks to install the radiator support opening cover.

    2. Install the 3 clips.

  7. INSTALL NO. 1 ENGINE COVER


    1. A01INMI

      Attach the 4 clips to install the No. 1 engine cover.

  8. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  9. INSTALL FRONT DRIVE SHAFT ASSEMBLY RH


    1. Install the front drive shaft assembly RH Click here.