ULTRASONIC SENSOR (for Rear) REMOVAL


  1. REMOVE NO. 1 FLOOR UNDER COVER


    1. A01ISJG

      Remove the 5 clips and No. 1 floor under cover.

  2. REMOVE REAR BUMPER COVER


    1. A01IMZC

      Remove the screw.

      Tech Tips

      Use the same procedure for the RH and LH sides.

    2. Put protective tape around the rear bumper cover.

    3. Remove the 5 clips and 2 bolts.

      A01ITTIE01
      Text in Illustration
      *1 Protective Tape - -

    4. Detach the 10 claws.

    5. w/ TOYOTA Parking Assist-sensor System:

      Disconnect the No. 4 floor wire connector.

    6. Remove the rear bumper cover.

      A01IOHRE01
      Text in Illustration
      *1 Protective Tape - -

  3. REMOVE NO. 4 FLOOR WIRE


    1. Remove the 3 pieces of tape.

    2. Disconnect the 4 connectors.

    3. Detach the 2 clamps and remove the No. 4 floor wire.

      A01IP7XE01
      Text in Illustration
      *1 Tape - -

  4. REMOVE NO. 1 ULTRASONIC SENSOR

    A01IRZT

    Tech Tips

    Use the same procedure for all No. 1 ultrasonic sensors.


    1. Detach the 2 claws and remove the No. 1 ultrasonic sensor.

  5. REMOVE ULTRASONIC SENSOR CLIP

    Tech Tips

    Use the same procedure for both ultrasonic sensor clips.


    1. A01INIHE02
      Text in Illustration
      *a Protective Tape

      Using a screwdriver, detach the claw and remove the ultrasonic sensor clip as shown in the illustration.

      Tech Tips

      Tape the screwdriver tip before use.

  6. REMOVE ULTRASONIC SENSOR RETAINER

    Tech Tips

    Use the same procedure for both ultrasonic sensor retainers.

    A01IQYZ

    1. Detach the 4 claws and remove the ultrasonic sensor retainer.