ULTRASONIC SENSOR (for Front) INSTALLATION


  1. INSTALL NO. 1 ULTRASONIC SENSOR RETAINER

    Tech Tips


    • Align the slit of the No. 1 ultrasonic sensor retainer with the protrusion of the front bumper cover and install the No. 1 ultrasonic sensor retainer.

    • Pay attention to the protrusions of the front bumper cover as the orientation of the retainer changes depending on the installation position.

    • Use the same procedure for all No. 1 ultrasonic sensor retainers.

    A01ITEBE01
    Text in Illustration
    *a Rear View of Front Bumper - -

    1. A01IQCAE02
      Text in Illustration
      *a Slit
      *b Protrusion

      Attach the 4 claws to install the No. 1 ultrasonic sensor retainer to the front bumper cover.

      Note

      Do not damage the bumper cover with the protrusion when installing the retainer.

  2. INSTALL NO. 1 ULTRASONIC SENSOR

    Tech Tips

    Use the same procedure for all No. 1 ultrasonic sensors.


    1. A01IRZT

      Attach the 2 claws to install the No. 1 ultrasonic sensor.

  3. INSTALL NO. 4 ENGINE ROOM WIRE


    1. Attach the 6 clamps to install the No. 4 engine room wire.

      A01IOTY

    2. Connect the 4 connectors.

  4. INSTALL FRONT BUMPER COVER


    1. Install the front bumper cover.


      1. w/ Headlight Cleaner System:

        Connect the headlight cleaner hose.

      2. Connect the 2 fog light connectors.

      3. w/ TOYOTA Parking Assist-sensor System:

        Connect the No. 4 engine room wire connector.

      4. Attach the 6 claws to install the front bumper cover.

    2. Install the bolt and 2 clips.

    3. A01IMYBE01
      Text in Illustration
      *a CORRECT
      *b INCORRECT

      Install the pin hold clip.

      Note

      Insert the pin hold clip with the slot aligned vertically. Do not rotate the clip after inserting it. After installation, confirm that the slot is vertical.

      Tech Tips

      Use the same procedure for the RH and LH sides.

    4. Install the screw.

      Tech Tips

      Use the same procedure for the RH and LH sides.

  5. INSTALL RADIATOR GRILLE PROTECTOR


    1. Install the 2 radiator grille protectors.

  6. INSTALL RADIATOR SUPPORT OPENING COVER


    1. A01IQMS

      Attach the 4 hooks to install the radiator support opening cover.

    2. Install the 3 clips.

  7. ADJUST FOG LIGHT ASSEMBLY

    Click here