ULTRASONIC SENSOR (for Front) REMOVAL


  1. REMOVE RADIATOR SUPPORT OPENING COVER


    1. A01IQMS

      Remove the 3 clips.

    2. Detach the 4 hooks and remove the radiator support opening cover.

  2. REMOVE RADIATOR GRILLE PROTECTOR

    A01IQXK

    1. Remove the 2 radiator grille protectors.

  3. REMOVE FRONT BUMPER COVER

    A01INTWE01

    1. Using a screwdriver, remove the pin hold clip.

      Tech Tips

      Use the same procedure for the RH and LH sides.

    2. Remove the screw.

      Tech Tips

      Use the same procedure for the RH and LH sides.

    3. Put protective tape around the front bumper cover.

    4. Remove the bolt and 2 clips.

      A01IQQPE01
      Text in Illustration
      *1 Protective Tape - -

    5. Remove the front bumper cover.


      1. Detach the 6 claws.

      2. w/ Headlight Cleaner System:

        Disconnect the headlight cleaner hose and then drain the washer fluid.

        Tech Tips

        Use a container to collect the washer fluid.

      3. Disconnect the 2 fog light connectors.

      4. w/ TOYOTA Parking Assist-sensor System:

        Disconnect the No. 4 engine room wire connector.

      5. Remove the front bumper cover.

        A01ITLFE01
        Text in Illustration
        *1 Protective Tape - -

  4. REMOVE NO. 4 ENGINE ROOM WIRE


    1. Disconnect the 4 connectors.

    2. Detach the 6 clamps and remove the No. 4 engine room wire.

      A01IOTY

  5. REMOVE NO. 1 ULTRASONIC SENSOR

    Tech Tips

    Use the same procedure for all ultrasonic sensors.


    1. A01IRZT

      Detach the 2 claws and remove the ultrasonic sensor.

  6. REMOVE NO. 1 ULTRASONIC SENSOR RETAINER

    A01IQYZ

    Tech Tips

    Use the same procedure for all No. 1 ultrasonic sensor retainers.


    1. Detach the 4 claws and remove the No. 1 ultrasonic sensor retainer.