TOYOTA PARKING ASSIST-SENSOR SYSTEM Front Corner Clearance Sonar Sensor RH Circuit

DESCRIPTION

The ultrasonic sensor sends and receives ultrasonic waves. Based on the received wave, the sensor calculates the approximate distance between the vehicle and the obstacle, and sends the distance value as a signal to the clearance warning ECU.

INSPECTION PROCEDURE

PROCEDURE

1. Click here

   INSPECT NO. 1 ULTRASONIC SENSOR (FRONT CORNER SENSOR RH)

   
   
   1. 

      Remove the No. 1 ultrasonic sensor (front corner sensor RH) (Click here).

   2. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition 1 (E) - 2 (S) Always 20 to 40 kΩ

   
   
   • OKClick here
   • NGClick here
2. Click here

   CHECK HARNESS AND CONNECTOR (FRONT CORNER SENSOR RH - CLEARANCE WARNING ECU)

   
   

   1. Disconnect the T1 No. 1 ultrasonic sensor (front corner sensor RH) connector.

   2. Disconnect the H95 clearance warning ECU connector.

   3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition T1-2 (S) - H95-34 (S5) Always Below 1 Ω T1-1 (E) - H95-33 (E5) Always Below 1 Ω T1-2 (S) - Body ground Always 10 kΩ or higher T1-1 (E) - Body ground Always 10 kΩ or higher

   
   
   • OKClick here
   • NGClick here
3. Click here

   PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLEClick here

4. Click here

   REPLACE NO. 1 ULTRASONIC SENSOR (FRONT CORNER SENSOR RH)Click here

5. Click here

   REPAIR OR REPLACE HARNESS OR CONNECTOR