TOYOTA PARKING ASSIST-SENSOR SYSTEM Front Corner Clearance Sonar Sensor LH Circuit

DESCRIPTION

The ultrasonic sensor sends and receives ultrasonic waves. Based on the received wave, the sensor calculates the approximate distance between the vehicle and the obstacle, and sends the distance value as a signal to the clearance warning ECU.

WIRING DIAGRAM

A01ISNOE04

INSPECTION PROCEDURE

PROCEDURE


  1. INSPECT NO. 1 ULTRASONIC SENSOR (FRONT CORNER SENSOR LH)


    1. A01IRBGE01

      Remove the No. 1 ultrasonic sensor (front corner sensor LH) Click here.

    2. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      1 (E) - 2 (S) Always 20 to 40 kΩ

    NG

    REPLACE NO. 1 ULTRASONIC SENSOR (FRONT CORNER SENSOR LH) Click here

    OK

  2. CHECK HARNESS AND CONNECTOR (FRONT CORNER SENSOR LH - CLEARANCE WARNING ECU)


    1. Disconnect the T4 No. 1 ultrasonic sensor (front corner sensor LH) connector.

    2. Disconnect the H95 clearance warning ECU connector.

    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      T4-2 (S) - H95-13 (S6) Always Below 1 Ω
      T4-1 (E) - H95-12 (E6) Always Below 1 Ω
      T4-2 (S) - Body ground Always 10 kΩ or higher
      T4-1 (E) - Body ground Always 10 kΩ or higher

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR

    OK

    PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE Click here