Click here

NAVIGATION SYSTEM Microphone Circuit between Radio Receiver and Extension Module

Click here
Click here Click here
DTC Code DTC Name
  Microphone Circuit between Radio Receiver and Extension Module
Click here

DESCRIPTION

This circuit sends a microphone voice signal from the navigation ECU to the radio and display receiver assembly.

Using this circuit, the navigation ECU disables the microphone function of the radio and display receiver assembly to receive a microphone voice signal from the telephone microphone assembly.

Click here

WIRING DIAGRAM

Click here

INSPECTION PROCEDURE

Note:

Check that the wire harness is properly installed and does not have any sharp bends, pinching or loose connections (Click here).

Click here

PROCEDURE


  1. Click here

    CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY - NAVIGATION ECU)


    1. Disconnect the z27 radio and display receiver assembly connector.

    2. Disconnect the z26 navigation ECU connector.

    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      z27-5 (MIC+) - z26-16 (MIC+) Always Below 1 Ω
      z27-6 (MIC-) - z26-17 (MIC-) Always Below 1 Ω
      z27-1 (SLD4) - z26-18 (MSHLD) Always Below 1 Ω
      z27-5 (MIC+) - Body ground Always 10 kΩ or higher
      z27-6 (MIC-) - Body ground Always 10 kΩ or higher
      z27-1 (SLD4) - Body ground Always 10 kΩ or higher

  2. Click here

    REPAIR OR REPLACE HARNESS OR CONNECTOR

  3. Click here

    PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLEClick here