Click here

INSTRUMENT PANEL SPEAKER REMOVAL

Click here
Click here Click here
Tip:

  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

Click here
  1. Click here

    PRECAUTION

    Note:

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work. (Click here).

  2. Click here

    DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).

  3. Click here

    REMOVE FRONT PILLAR GARNISH LH


    1. Pull the upper part of the garnish toward the inside of the cabin and detach the 2 clips.

      Tip:

      Allow the front pillar garnish to hang by the front pillar garnish clip.

      Table 1. Text in Illustration
      *1 Front Pillar Garnish Clip
    2. A01ISK0E01

      Turn the end of the front pillar garnish clip 90° with needle-nose pliers and remove it from the front pillar garnish.

      Note:

      • Front pillar garnish clips are reusable if they are not removed from the vehicle and have no damage.

      • Replace the front pillar garnish clips with new ones if they are removed from the vehicle.

      Tip:

      Tape the tips of the needle-nose pliers before use.

      Table 2. Text in Illustration
      *1 Front Pillar Garnish Clip
      *2 Protective Tape

    3. Detach the 2 claws and remove the front pillar garnish.

    4. A01IR1KE01

      w/ Curtain Shield Airbag:

      Protect the curtain shield airbag assembly.


      1. Completely cover the airbag with a cloth or nylon sheet and secure the ends of the cover with adhesive tape as shown in the illustration.

        Note:

        Cover the curtain shield airbag with a protective cover as soon as the front pillar garnish is removed.

        Table 3. Text in Illustration
        *1 Curtain Shield Airbag Assembly
        *2 Adhesive Tape
        *3 Protective Cover
  4. Click here

    REMOVE NO. 1 INSTRUMENT PANEL SPEAKER PANEL SUB-ASSEMBLY


    1. A01IUSL

      Detach the claws and clips shown in the illustration on the bottom of the panel. Then, using the 2 claws on the side of the panel towards the front of the vehicle as pivot points, lift up the panel in the direction indicated by the arrow in the illustration until the speaker connector can be disconnected.

    2. A01IREG

      Disconnect the connector and remove the panel together with the speaker.

  5. Click here

    REMOVE FRONT NO. 2 SPEAKER ASSEMBLY


    1. A01IT78

      Detach the 3 claws and remove the front No. 2 speaker from the speaker panel.

      Note:

      Do not touch the cone part of the speaker.