Click here

FRONT DOOR SPEAKER REMOVAL

Click here
Click here Click here
Tip:

  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

Click here
  1. Click here

    PRECAUTION

    Note:

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work. (Click here).

  2. Click here

    DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).

  3. Click here

    REMOVE FRONT DOOR INSIDE HANDLE BEZEL LH


    1. A01IQLV

      Using moulding remover A, detach the 3 claws and remove the inside handle bezel.

  4. Click here

    REMOVE FRONT DOOR TRIM MOULDING LH


    1. A01IS9F

      Using moulding remover A, detach the 8 claws and remove the front door trim moulding.

  5. Click here

    REMOVE POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL


    1. A01IN0RE01

      Using moulding remover A, detach the clip and 7 claws and remove the power window regulator master switch assembly with front door armrest base panel.

    2. Disconnect the connector.

  6. Click here

    REMOVE POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Front Passenger Side)

    Tip:

    Use the same procedure described for the driver side.

  7. Click here

    REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH


    1. A01IR1B

      Remove the 3 screws.

    2. Remove the 9 clips.

    3. w/ Courtesy Light:


      1. Disconnect the courtesy light connector.

    4. A01IP9CE01

      Pull out the front door trim board in the direction indicated by the arrow.

      Table 1. Text in Illustration
      *1 Reference Boss
    5. A01IUDS

      Disconnect the 2 cables from the inside handle.

  8. Click here

    REMOVE FRONT DOOR INSIDE HANDLE SUB-ASSEMBLY LH


    1. A01IUHM

      Detach the 2 claws and remove the inside handle sub-assembly from the door trim board.

  9. Click here

    REMOVE FRONT NO. 1 SPEAKER ASSEMBLY

    Note:

    Do not touch the cone part of the speaker.


    1. Disconnect the speaker connector.

    2. A01IN56

      Using a drill bit with a diameter of less than 4 mm (0.157 in.), drill out the 3 rivet heads.

      CAUTION:

      Be careful as the cut rivet will be very hot.

      Note:

      Do not drill the rivet at an angle as this will cause damage to the drill and drill hole. Line up the drill and rivet, and carefully drill out the rivet head.

    3. Continue drilling and push out the remaining rivet fragments.

    4. Using a vacuum cleaner, remove the rivet fragments and shavings from the inside of the door.

    5. Detach the claw and remove the speaker.