AUDIO AND VISUAL SYSTEM (for Radio and Display Type) Sound Signal Circuit between Radio Receiver and Stereo Jack Adapter

DESCRIPTION

The No. 1 stereo jack adapter assembly sends an external device sound signal to the radio and display receiver assembly through this circuit.

If there is an open or short in the circuit, sound cannot be heard from the speakers even if there is no malfunction in the radio and display receiver assembly or speakers.

WIRING DIAGRAM

A01IRF3E08

INSPECTION PROCEDURE

PROCEDURE


  1. CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY - NO. 1 STEREO JACK ADAPTER ASSEMBLY)


    1. Disconnect the H105 radio and display receiver assembly connector.

    2. Disconnect the H104 No. 1 stereo jack adapter assembly connector.

    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      H105-26 (VAR+) - H104-5 (ARO) Always Below 1 Ω
      H105-28 (VAL+) - H104-6 (ALO)
      H105-27 (VA-) - H104-7 (ASGN)
      H105-25 (ADPG) - H104-8 (AUXO)
      H105-11 (AGND) - H104-9 (AGND)
      H105-26 (VAR+) - Body ground Always 10 kΩ or higher
      H105-28 (VAL+) - Body ground
      H105-27 (VA-) - Body ground
      H105-25 (ADPG) - Body ground
      H105-11 (AGND) - Body ground

    NG
    OK