AUDIO AND VISUAL SYSTEM (for Radio and Display Type) Steering Pad Switch Circuit

DESCRIPTION

This circuit sends an operation signal from the steering pad switch to the radio and display receiver assembly.

If there is an open in the circuit, the audio system cannot be operated using the steering pad switch.

If there is a short in the circuit, the same condition as when a switch is continuously depressed occurs.

Therefore, the radio and display receiver assembly cannot be operated using the steering pad switch and the radio and display receiver assembly itself cannot function.

WIRING DIAGRAM

A01IO9VE02

INSPECTION PROCEDURE

CAUTION:

The vehicle is equipped with an SRS (Supplemental Restraint System) which includes components such as airbags. Before servicing (including removal or installation of parts), be sure to read the Precaution in the Supplemental Restraint System Click here.

PROCEDURE


  1. INSPECT STEERING PAD SWITCH ASSEMBLY


    1. Remove the steering pad switch assembly Click here.

    2. Inspect the steering pad switch assembly Click here.


    NG
    OK
  2. INSPECT SPIRAL WITH SENSOR CABLE SUB-ASSEMBLY


    1. Remove the spiral with sensor cable sub-assembly Click here.

    2. Inspect the spiral with sensor cable sub-assembly Click here.


    NG
    OK
  3. CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY - SPIRAL WITH SENSOR CABLE SUB-ASSEMBLY)


    1. Disconnect the H105 radio and display receiver assembly connector.

    2. Disconnect the H11 spiral with sensor cable sub-assembly connector.

    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      H105-21 (SW1) - H11-6 (AU1) Always Below 1 Ω
      H105-22 (SW2) - H11-5 (AU2)
      H105-23 (SWG) - H11-4 (EAU)
      H105-21 (SW1) - Body ground Always 10 kΩ or higher
      H105-22 (SW2) - Body ground
      H105-23 (SWG) - Body ground

    NG
    OK