Click here

REAR BUMPER REASSEMBLY

Click here
Click here Click here
  1. Click here

    INSTALL REFLEX REFLECTOR ASSEMBLY LH


    1. Attach the guide to install the reflex reflector assembly.

    2. Install the screw.

  2. Click here

    INSTALL REFLEX REFLECTOR ASSEMBLY RH

    Tip:

    Use the same procedure described for the LH side.

  3. Click here

    INSTALL ULTRASONIC SENSOR RETAINER (w/ TOYOTA Parking Assist-sensor System)

    A01IOI4E01
    Tip:

    • Align the slit of the ultrasonic sensor retainer with the protrusion of the rear bumper cover and install the ultrasonic sensor retainer.

    • Pay attention to the protrusions of the rear bumper cover as the orientation of the retainer changes depending on the installation position.

    • Use the same procedure for both ultrasonic sensor retainers.

    Table 1. Text in Illustration
    *a Rear View of Rear Bumper - -

    1. A01IQCAE03

      Attach the 4 claws to install the ultrasonic sensor retainer to the rear bumper cover.

      Note:

      Do not damage the bumper cover with the protrusion when installing the retainer.

      Table 2. Text in Illustration
      *a Slit
      *b Protrusion
  4. Click here

    INSTALL NO. 1 ULTRASONIC SENSOR (w/ TOYOTA Parking Assist-sensor System)

    Tip:

    Use the same procedure for all ultrasonic sensors.


    1. Attach the 2 claws to install the ultrasonic sensor.

  5. Click here

    INSTALL NO. 4 FLOOR WIRE (w/ TOYOTA Parking Assist-sensor System)


    1. When using a new rear bumper cover:

      Clean the rear bumper cover surface.

    2. When reusing the rear bumper cover:

      Wipe off any tape adhesive residue with cleaner.

    3. Attach the 2 clamps to install the No. 4 floor wire.

    4. Connect the 4 connectors.

    5. A01IP7XE01

      Install 3 new pieces of tape as shown in the illustration.

      Tip:

      Align the tape with the mark-off line of the rear bumper.

      Table 3. Text in Illustration
      *1 Tape - -