AUTOMATIC LIGHT CONTROL SENSOR INSTALLATION

Tech Tips


  • Use the same procedure for LHD and RHD vehicles.

  • The procedure listed below is for LHD vehicles.


  1. INSTALL RAIN SENSOR

    Note

    If the tape is damaged, replace the rain sensor.


    1. Clean the surface of the windshield glass that contacts the rain sensor.

    2. When replacing the rain sensor with a new one:

      Remove the protective cover on the rain sensor.

      Note

      Do not touch the silicon mixture directly with your finger.

    3. A01INSW

      Connect the connector.

      Note

      Do not touch the silicon mixture directly with your finger.

    4. A01INFS

      Attach the 2 claws to install the rain sensor as shown in the illustration.

      Note

      Make sure that there are no air bubbles between the silicon mixture and windshield glass.

  2. INSTALL NO. 2 RAIN SENSOR COVER


    1. A01INHA

      Using a screwdriver, attach the 2 claws to install the No. 2 rain sensor cover.

  3. INSTALL NO. 1 RAIN SENSOR COVER


    1. A01IRSM

      Attach the 2 claws to connect the No. 1 rain sensor cover.

      Note

      Be careful not to damage the No. 1 rain sensor cover.

    2. A01INIG

      Attach the 3 claws to install the No. 1 rain sensor cover.