Click here

LIGHTING SYSTEM Warning Light Circuit

Click here
Click here Click here
DTC Code DTC Name
  Warning Light Circuit
Click here

DESCRIPTION

The headlight beam level control system warning light in the combination meter assembly comes on for approximately 3 seconds when the ignition switch is turned to ON. The warning light also comes on when the headlight leveling ECU detects a malfunction.

Click here

WIRING DIAGRAM

Click here

INSPECTION PROCEDURE

Click here

PROCEDURE


  1. Click here

    INSPECT COMBINATION METER ASSEMBLY


    1. Remove the combination meter assembly (Click here).

    2. Connect the positive (+) lead from the battery to terminal 39 (IG+) and the negative (-) lead to terminal 12 (LVWG).

    3. Check that the warning light comes on.

      OK
      Warning light comes on.

  2. Click here

    CHECK HARNESS AND CONNECTOR (BATTERY - COMBINATION METER ASSEMBLY)


    1. Disconnect the H62 combination meter connector.

    2. Measure the voltage according to the value(s) in the table below.

      Standard Voltage
      Tester Connection Switch Condition Specified Condition
      H62-39 (IG+) - Body ground Ignition switch ON 11 to 14 V
      Ignition switch off Below 1 V
      Table 1. Text in Illustration
      *1

      Front view of wire harness connector

      (to Combination Meter Assembly)

  3. Click here

    CHECK HARNESS AND CONNECTOR (COMBINATION METER ASSEMBLY - HEADLIGHT LEVELING ECU ASSEMBLY)


    1. Disconnect the A49 ECU connector.

    2. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      A49-6 (WNG) - H62-12 (LVWG) Always Below 1 Ω
      A49-6 (WNG) - Body ground Always 10 kΩ or higher
      Table 2. Text in Illustration
      *1

      Front view of wire harness connector

      (to Combination Meter Assembly)
      *2

      Front view of wire harness connector

      (to Headlight Leveling ECU Assembly)

  4. Click here

    REPAIR OR REPLACE HARNESS OR CONNECTOR

  5. Click here

    REPLACE COMBINATION METER ASSEMBLYClick here

  6. Click here

    PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLEClick here