WIPER ECU (for LHD) REMOVAL


  1. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  3. REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

    A01IO1E

    1. Detach the 3 claws and guide, and remove the No. 2 instrument panel under cover.

  4. REMOVE GLOVE COMPARTMENT DOOR ASSEMBLY

    A01IP4S

    1. Push in the sides of the glove compartment door to release the 2 stoppers and open the glove compartment door until it is horizontal.

    2. Detach the glove compartment door stopper from the glove compartment door as shown in the illustration.

    3. A01IP3S

      Pull the glove compartment door toward the rear of the vehicle to detach the 2 hinges and remove the glove compartment door.

  5. REMOVE ECU INTEGRATION BOX RH


    1. A01IPUV

      Detach the clamp.

    2. Disconnect each connector.

    3. A01IPUU

      Remove the 2 nuts and bolt, and ECU integration box RH.

  6. REMOVE WINDSHIELD WIPER RELAY ASSEMBLY


    1. A01IUMC

      Detach the 2 claws and remove the windshield wiper relay assembly.