REAR WIPER MOTOR INSTALLATION


  1. INSTALL REAR WIPER MOTOR GROMMET


    1. A01IOUPE01
      Text in Illustration
      *1 MP grease

      Apply MP grease to the entire inner surface of the wiper motor grommet.

      Tech Tips

      Make sure that the hole does not get clogged with grease and the grooves in the grommet are filled with grease.

    2. A01IUK1E01
      Text in Illustration
      *1 Position Mark

      Install the rear wiper motor grommet with the position mark facing upward as shown in the illustration.

  2. INSTALL REAR WIPER MOTOR AND BRACKET ASSEMBLY


    1. A01IQRE

      Temporarily install the rear wiper motor and bracket assembly with the 3 bolts.

    2. Tighten the 3 bolts.

      Torque:
      5.5 N*m  { 56 kgf*cm, 49 in.*lbf }

    3. Connect the connector.

  3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  4. INSTALL REAR WIPER ARM


    1. Operate the rear wiper, and stop the rear wiper motor at the automatic stop position.

    2. A01INMQE01
      Text in Illustration
      *1 Wiper Arm Pivot Serrations
      *2 Wire Brush
      *3 Wiper Pivot Serrations

      Clean the serrations with a wire brush.

    3. A01IQQ1E01
      Text in Illustration
      *1 Mark for Blade Position

      Align the blade tip with the mark on the glass, as shown in the illustration.

    4. A01ISLG

      Install the rear wiper arm with the nut.

      Torque:
      5.5 N*m  { 56 kgf*cm, 49 in.*lbf }

    5. Close the wiper arm head cap.

  5. INSTALL BACK DOOR TRIM PANEL ASSEMBLY


    1. A01IPJU

      Attach the 12 clips to install the back door trim.

    2. A01ITD9

      Attach the clip.

  6. INSTALL BACK DOOR INSIDE HANDLE


    1. A01IN27

      Attach the 4 claws to install the door inside handle.

  7. INSTALL BACK DOOR SIDE GARNISH LH


    1. A01IUHF

      Attach the 2 clips and claw to install the back door side garnish.

  8. INSTALL BACK DOOR SIDE GARNISH RH


    1. A01IOOI

      Attach the 2 clips and claw to install the back door side garnish.

  9. INSTALL CENTER BACK DOOR GARNISH


    1. A01IOP0

      Attach the 4 claws and 4 clips to install the center back door garnish.