REAR WIPER MOTOR REMOVAL


  1. REMOVE BATTERY SERVICE HOLE COVER


    1. A01ITOM

      Remove the clip and battery service hole cover.

  2. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

  3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  4. REMOVE CENTER BACK DOOR GARNISH


    1. A01IOP0

      Detach the 4 clips and 4 claws, and remove the center back door garnish.

  5. REMOVE BACK DOOR SIDE GARNISH LH


    1. A01IUHF

      Detach the 2 clips and claw, and remove the back door side garnish.

  6. REMOVE BACK DOOR SIDE GARNISH RH


    1. A01IOOI

      Detach the 2 clips and claw, and remove the back door side garnish.

  7. REMOVE BACK DOOR INSIDE HANDLE


    1. A01IS72

      Using moulding remover D, detach the 4 claws and remove the back door inside handle.

  8. REMOVE BACK DOOR TRIM PANEL ASSEMBLY


    1. A01ITD9

      Detach the clip.

    2. A01IPJU

      Detach the 12 clips and remove the back door trim board.

  9. REMOVE REAR WIPER ARM


    1. A01IR64

      Open the wiper arm head cap.

    2. A01ISLG

      Remove the nut and rear wiper arm.

  10. REMOVE REAR WIPER MOTOR AND BRACKET ASSEMBLY


    1. A01IQRE

      Disconnect the connector.

    2. Remove the 3 bolts and rear wiper motor and bracket assembly.

  11. REMOVE REAR WIPER MOTOR GROMMET


    1. A01IPTL

      Remove the wiper motor grommet.