WIPER AND WASHER SYSTEM (w/ Rain Sensor) HOW TO PROCEED WITH TROUBLESHOOTING

Tech Tips


  • Use these procedures to troubleshoot the wiper and washer system.

  • *: Use the intelligent tester.


  1. VEHICLE BROUGHT TO WORKSHOP


    NEXT

  2. INSPECT BATTERY VOLTAGE

    Standard voltage
    11 to 14 V

    • If the voltage is below 11 V, recharge or replace the battery before proceeding.


    NEXT

  3. CHECK COMMUNICATION FUNCTION OF LIN COMMUNICATION SYSTEM*


    1. Check that the LIN communication system is normal. Click here

      OK
      LIN communication system is normal.

      B

      Go to LIN COMMUNICATION SYSTEM Click here

      A

  4. PROBLEM SYMPTOMS TABLE

    Result
    Result Proceed to
    Fault is not listed in problem symptoms table A
    Fault is listed in problem symptoms table B

    B

    Go to step 6
    A

  5. OVERALL ANALYSIS AND TROUBLESHOOTING*


    1. Terminals of ECU Click here.

    2. Data List / Active Test Click here.


      NEXT

  6. REPAIR OR REPLACE


    NEXT

  7. CONFIRMATION TEST


    NEXT
    END