Click here

OUTER REAR VIEW MIRROR REMOVAL

Click here
Click here Click here
Tip:

  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.

  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

Click here
  1. Click here

    REMOVE FRONT DOOR INSIDE HANDLE BEZEL LH


    1. A01IQLV

      Using moulding remover A, detach the 3 claws and remove the inside handle bezel.

  2. Click here

    REMOVE FRONT DOOR TRIM MOULDING LH


    1. A01IS9F

      Using moulding remover A, detach the 8 claws and remove the front door trim moulding.

  3. Click here

    REMOVE POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Driver Side)


    1. A01IN0RE01

      Using moulding remover A, detach the clip and 7 claws and remove the power window regulator master switch assembly with front door armrest base panel.

    2. Disconnect the connector.

  4. Click here

    REMOVE POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Front Passenger Side)

    Tip:

    Use the same procedure described for the driver side.

  5. Click here

    REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH


    1. A01IR1B

      Remove the 3 screws.

    2. Remove the 9 clips.

    3. w/ Courtesy Light:


      1. Disconnect the courtesy light connector.

    4. A01IP9CE01

      Pull out the front door trim board in the direction indicated by the arrow.

      Table 1. Text in Illustration
      *1 Reference Boss
    5. A01IUDS

      Disconnect the 2 cables from the inside handle.

  6. Click here

    REMOVE FRONT DOOR INSIDE HANDLE SUB-ASSEMBLY LH


    1. A01IUHM

      Detach the 2 claws and remove the inside handle sub-assembly from the door trim board.

  7. Click here

    REMOVE FRONT DOOR INNER GLASS WEATHERSTRIP LH


    1. A01IUMH

      Detach the 5 claws and remove the weatherstrip.

  8. Click here

    REMOVE OUTER MIRROR INSTALL HOLE COVER LH


    1. A01ISLX

      Using moulding remover D, detach the 3 claws and remove the outer mirror install hole cover.

  9. Click here

    REMOVE FRONT DOOR SERVICE HOLE COVER LH


    1. A01IOWT

      Disconnect the 2 connectors and remove the service hole cover.

      Tip:

      Remove the remaining tape on the door.

  10. Click here

    REMOVE OUTER REAR VIEW MIRROR ASSEMBLY LH


    1. Disconnect the connector.

    2. Detach the clamp.

    3. Remove the 3 bolts, detach the claw and remove the outer rear view mirror assembly LH.