REAR SHOCK ABSORBER REMOVAL

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.


  1. REMOVE DECK TRIM SIDE PANEL ASSEMBLY LH


    1. Remove the deck trim side panel assembly LH Click here.

  2. REMOVE REAR WHEEL

  3. REMOVE REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY RH (w/ HID Headlight)


    1. A01ITMT

      Remove the 2 bolts and rear height control sensor.

    2. Disconnect the connector.

  4. REMOVE REAR SHOCK ABSORBER CUSHION RETAINER


    1. A01IOG9

      Support the spring seat of the rear axle beam assembly using a jack and wooden block.

      Note


      • Do not excessively jack up the rear axle beam assembly.

      • When moving the rear axle beam assembly beyond full rebound, make sure that the beam is not out of position for more than 10 minutes.

      Tech Tips

      Support the rear shock absorber at a position where it compresses by approximately 20 to 30 mm (0.787 to 1.18 in.).

    2. A01IN8F

      Using a 6 mm socket hexagon wrench, secure the rear shock absorber rod and remove the lock nut.

    3. A01IURYE01

      Remove the rear shock absorber cushion retainer.

  5. REMOVE REAR SUSPENSION SUPPORT ASSEMBLY LH


    1. Remove the rear suspension support.

  6. REMOVE REAR SHOCK ABSORBER ASSEMBLY LH


    1. A01ISUR

      Remove the bolt while holding the nut and remove the rear shock absorber.

  7. REMOVE REAR BUMPER SPRING LH


    1. A01IPWF

      Remove the rear bumper spring from the rear shock absorber.