REAR AXLE HUB REMOVAL

Tech Tips


  • Use the same procedures for the RH side and LH side.

  • The procedures listed below are for the LH side.


  1. REMOVE REAR WHEEL

  2. REMOVE REAR DISC BRAKE CYLINDER ASSEMBLY LH


    1. A01IQLJ

      Remove the 2 bolts and disconnect the rear disc brake cylinder.

      Note


      • Do not disconnect the flexible hose from the disc brake cylinder.

      • Do not twist or bend the flexible hose.

    2. Hang the disc brake cylinder with a piece of wire.

  3. REMOVE REAR DISC


    1. A01IT27E01
      Text in Illustration
      *1 Matchmark

      Put matchmarks on the rear disc and axle hub if planning to reuse the disc.

    2. Remove the shoe adjusting hole plug.

    3. A01IN9O

      Turn the shoe adjuster until the disc turns freely, and then remove the disc.

  4. DISCONNECT SKID CONTROL SENSOR WIRE


    1. A01IRNB

      Disconnect the connector.

  5. REMOVE REAR AXLE HUB AND BEARING ASSEMBLY LH


    1. A01IN1O

      Remove the 4 bolts and the rear axle hub and bearing assembly.