REAR AXLE HUB BOLT REPLACEMENT

Tech Tips


  • Use the same procedures for the RH side and LH side.

  • The procedures listed below are for the LH side.


  1. REMOVE REAR WHEEL

  2. DISASSEMBLY PARKING BRAKE ASSEMBLY


    1. Disassemble the parking brake assembly Click here.

  3. REPLACE REAR AXLE HUB BOLT


    1. A01IS56E01
      Text in Illustration
      *1 Nut

      Temporarily install 2 nuts and 2 washers to 2 rear axle hub bolts as shown in the illustration.

    2. Using SST and a brass bar or an equivalent tool to hold the hub and bearing assembly, remove the rear axle hub bolt.

      SST
      09611-12010
    3. A01IPHDE01
      Text in Illustration
      *1 Washer
      *2 Nut

      Install a washer and nut to a new rear axle hub bolt as shown in the illustration.

    4. Using a brass bar or an equivalent tool to hold the hub and bearing assembly, install the rear axle hub bolt by tightening the nut.

  4. REASSEMBLY PARKING BRAKE ASSEMBLY


    1. Reassemble the parking brake assembly Click here.

  5. INSTALL REAR WHEEL

    Torque:
    103 N*m  { 1050 kgf*cm, 76 ft.*lbf }