Click here

REVOLUTION SENSOR INSPECTION

Click here
Click here Click here
  1. Click here

    INSPECT TRANSMISSION REVOLUTION SENSOR (NIN)


    1. A01IP67E01

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      1 (NIN-) - 2 (NIN +) 20°C (68°F) 560 to 680 Ω

      • If the result is not as specified, replace the transmission revolution sensor (NIN).

      Table 1. Text in Illustration
      *a

      Component without harness connected

      (Transmission Revolution Sensor (NIN))
  2. Click here

    INSPECT TRANSMISSION REVOLUTION SENSOR (NOUT)


    1. A01ITZJE12

      Wave a magnetic object left and right in front of the transmission revolution sensor (NOUT) tip (5 mm (0.197 in.) or less) to change the high/low signals while measuring the current.

      Table 2. Text in Illustration
      *1 Battery - -
      *a

      Component without harness connected

      (Transmission Revolution Sensor (NOUT))

      		 *b Magnet
      *c 5 mm (0.197 in.) or less *d Ammeter
      Note:

      Make sure to wave the magnetic object during the inspection. Current will not change without waving the magnetic object as indicated by the arrow in the illustration.

    2. Measure the current according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      1 (NOTO) - 2 (NOTB) Low signal 4 to 8 mA
      High signal 12 to 16 mA

      • If the result is not as specified, replace the transmission revolution sensor (NOUT).