SHIFT PADDLE SWITCH INSTALLATION

INSTALL TRANSMISSION SHIFT SWITCH ASSEMBLY
1. Install the 2 shift switches and 2 brackets with the 4 screws.
  
  Torque:
  
  1.7 N*m { 17 kgf*cm, 15 in.*lbf }
  
  Note
  
  Make sure that the brackets are securely installed.
2. Connect the 3 switch wire connectors to the 2 shift switches and steering pad switch harness connector.
3. Attach the 2 harness clamps.
PLACE FRONT WHEELS FACING STRAIGHT AHEAD
ADJUST SPIRAL CABLE
1. Turn the ignition switch off.
2. Disconnect the cable from the negative (-) battery terminal.
  
  CAUTION:
  
  Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
3. Rotate the spiral cable counterclockwise slowly by hand until it feels firm.
  
  CAUTION:
  
  Do not turn the spiral cable by the airbag wire harness.
4. Rotate the spiral cable clockwise approximately 2.5 turns to align the marks.
  
  CAUTION:
  
  Do not turn the spiral cable by the airbag wire harness.
  
  Tech Tips
  
  The spiral cable can be rotated approximately 2.5 turns to both the left and right from the center.
INSTALL STEERING WHEEL ASSEMBLY
1. Text in Illustration
  
  *1 Matchmark
  
  Align the matchmarks on the steering wheel assembly and steering main shaft.
2. Install the steering wheel assembly set nut.
  
  Torque:
  
  50 N*m { 510 kgf*cm, 37 ft.*lbf }
3. Connect the connectors to the spiral cable sub-assembly.
INSTALL STEERING PAD
1. Support the steering pad with one hand.
2. Connect the connector to the steering pad.
  
  Note
  
  When handling the airbag connector, take care not to damage the airbag wire harness.
3. Connect the horn connector.
4. Attach the 2 springs to install the steering pad.
INSPECT STEERING WHEEL CENTER POINT
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Note

When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.
INSPECT SRS WARNING LIGHT
1. Inspect the SRS warning light Click here.