Click here

SHIFT LEVER REMOVAL

Click here
Click here
  1. Click here

    REMOVE LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL


    1. Remove the lower No. 1 instrument panel finish panel (Click here).

  2. Click here

    DISCONNECT TRANSMISSION CONTROL CABLE ASSEMBLY


    1. Move the shift lever to N.

    2. A01IPDG

      Disconnect the end of the transmission control cable from the shift lever assembly.

    3. A01ITR7E01

      Pull out the stopper of the transmission control cable.

      Table 1. Text in Illustration
      *1 Stopper
      *2 Nut
      Note:

      Do not remove the stopper. If the stopper is removed, reinstall it to its original position.

    4. Rotate the nut counterclockwise approximately 180° and, while holding the nut in that position, disconnect the transmission control cable from the shift lever retainer.

      Note:

      Do not over-rotate the nut as it will come off the internal spring and the transmission control cable will not be reusable.

  3. Click here

    REMOVE SHIFT LEVER ASSEMBLY


    1. Disconnect the 2 connectors, detach the 2 clamps and disconnect the wire harness from the shift lever.

    2. A01IS1T

      Remove the 4 nuts and shift lever.