BACK-UP LIGHT SWITCH REMOVAL


  1. REMOVE NO. 2 CYLINDER HEAD COVER


    1. A01IRS7

      Hold the rear of the cover and raise it to detach the 2 clips on the rear of the cover. Continue to raise the cover to detach the 2 clips on the front of the cover and remove the cover.

      Note

      Attempting to detach both front and rear clips at the same time may cause the cover to break.

  2. REMOVE AIR CLEANER CAP SUB-ASSEMBLY


    1. A01ISEG

      Disconnect the mass air flow meter connector.

    2. Detach the 2 clamps and disconnect the wire harness.

    3. A01IP4V

      Disconnect the 2 clamps.

    4. A01IPUC

      Disconnect the PCV hose.

    5. Loosen the band and remove the air cleaner cap.

  3. REMOVE AIR CLEANER CASE SUB-ASSEMBLY


    1. A01IQF0

      Detach the wire harness clamp from the air cleaner case.

    2. Remove the 3 bolts and air cleaner case.

  4. REMOVE BACK-UP LIGHT SWITCH ASSEMBLY


    1. Disconnect the back-up light switch connector.

    2. A01IS9GE01

      Using SST, remove the back-up light switch and gasket from the transaxle case.

      SST
      09817-16011