SHIFT AND SELECT LEVER SHAFT REASSEMBLY


  1. INSTALL SELECT STOPPER BLOCK


    1. Coat the select stopper block with gear oil.

    2. A01IPMIE01

      Install the select stopper block as shown in the illustration.

      Note

      Make sure the installation direction is correct.

    3. A01ITEWE01

      Using a 5 mm pin punch and hammer, install the slotted spring pin to the shift and select lever shaft.

      Standard depth
      -0.2 to 0.8 mm (-0.00787 to 0.0315 in.)

  2. INSTALL RELEASE HEAD STRAIGHT PIN


    1. A01IP7Q

      Install the release head straight pin to the select stopper block.

    2. Coat the release head with gear oil.

    3. A01IOCQE01

      Install the release head as shown in the illustration.

      Note

      Make sure the installation direction is correct.

    4. A01IOHVE01

      Install the release head torsion spring as shown in the illustration.

      Note

      Make sure the installation direction is correct.

    5. Coat the front inner shift lever with gear oil.

    6. A01ISIW

      Install the front inner shift lever as shown in the illustration.

      Note

      Make sure the installation direction is correct.

      Tech Tips

      Insert the torsion spring into the installation hole of the front inner shift lever.

    7. A01IN1HE02
      Text in Illustration
      *1 Spring
      *2 Straight Pin

      Turn the front inner shift lever counterclockwise to align its hole with the straight pin, and insert the straight pin into the hole.

      Note

      Make sure that the front shift lever is installed as shown in the illustration.

    8. A01IOAOE01

      Using a 5 mm pin punch and hammer, install the slotted spring pin to the shift and select lever shaft.

      Standard depth
      -0.2 to 0.8 mm (-0.00787 to 0.0315 in.)

  3. INSTALL INNER NO. 2 SHIFT LEVER


    1. Coat the inner No. 2 shift lever with gear oil.

    2. A01IN3PE01

      Using a 5 mm pin punch and hammer, install the inner No. 2 shift lever and slotted spring pin onto the shift and select lever shaft.

      Standard depth
      0 to 0.6 mm (0 to 0.0236 in.)

      Note

      Make sure the installation direction is correct.