TRANSMISSION CONTROL CABLE REMOVAL


  1. REMOVE FRONT EXHAUST PIPE ASSEMBLY


    1. Remove the front exhaust pipe assembly Click here.

  2. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here

  3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  4. DISCONNECT CABLE FROM POSITIVE BATTERY TERMINAL

  5. REMOVE NO. 2 CYLINDER HEAD COVER


    1. A01IRS7

      Hold the rear of the cover and raise it to detach the 2 clips on the rear of the cover. Continue to raise the cover to detach the 2 clips on the front of the cover and remove the cover.

      Note

      Attempting to detach both front and rear clips at the same time may cause the cover to break.

  6. REMOVE BATTERY CLAMP SUB-ASSEMBLY


    1. A01IQN6E01

      Disconnect the cable from the positive (+) battery terminal.

    2. Remove the bolt and loosen the nut.

    3. Remove the battery clamp.

  7. REMOVE BATTERY

  8. REMOVE BATTERY TRAY

  9. REMOVE BATTERY CARRIER


    1. A01INC1

      Disconnect the 2 wire harness clamps from the battery carrier.

    2. Remove the 2 bolts and disconnect the radiator pipe from the battery carrier.

    3. A01IN2I

      Remove the 4 bolts and battery carrier.

  10. REMOVE AIR CLEANER CAP SUB-ASSEMBLY


    1. A01ISEG

      Disconnect the mass air flow meter connector.

    2. Detach the 2 clamps and disconnect the wire harness.

    3. A01IP4V

      Disconnect the 2 clamps.

    4. A01IPUC

      Disconnect the PCV hose.

    5. Loosen the band and remove the air cleaner cap.

  11. REMOVE AIR CLEANER CASE


    1. A01IQF0

      Detach the wire harness clamp from the air cleaner case.

    2. Remove the 3 bolts and air cleaner case.

  12. REMOVE LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL

    Click here

  13. REMOVE FRONT NO. 1 FLOOR HEAT INSULATOR

    A01IT4Y

    1. Remove the 3 nuts and front No. 1 floor heat insulator.

  14. REMOVE TRANSMISSION CONTROL CABLE ASSEMBLY


    1. A01IPQME02
      Text in Illustration
      *1 Select Cable
      *2 Shift Cable

      Disconnect the control shift cable from the shift lever assembly.

    2. Pinch the areas indicated by the arrows and disconnect the control select cable.

    3. A01IUJQ

      Detach the 2 claws and disconnect the control cable assembly.

    4. A01IOZW

      Remove the 2 clips and disconnect the 2 cables from the transaxle.

    5. A01IRNL

      Remove the 2 clips and disconnect the 2 cables from the control cable bracket.

    6. A01IOFU

      Remove the bolt and detach the bracket of the control cable assembly.

    7. A01IQR5

      Remove the 2 nuts and detach the grommet of the control cable assembly.