TRANSMISSION CONTROL CABLE ADJUSTMENT


  1. ADJUST CONTROL SELECT CABLE

    Tech Tips


    • After the shift lever or transmission control cable assembly is replaced, be sure to adjust the control select cable.

    • If the shift lever cannot be moved (or the shift lever is difficult to move) to 1 or 2, or if it is possible to move the shift lever to R without pulling up the slider shaft, the length of the cable must be adjusted.


    1. A01IPQME01
      Text in Illustration
      *1 Select Cable

      Pinch the areas indicated by the arrows and disconnect the control select cable.

    2. Release the lock of the cable length adjustment structure of the select cable.


      1. A01INGTE02

        Turn the stopper.

      2. A01IOTDE02

        Pull the lock piece outward from the case to release the lock.

      3. A01IS8RE01

        Return the stopper.

    3. A01IR15E01
      Text in Illustration
      *1 Reverse Restrict Pin Assembly
      *2 Outer Lever

      Hook the outer lever of the manual transaxle onto the reverse restrict pin assembly to secure it.

    4. A01IQCHE02

      Connect the control select cable to the shift lever assembly.

    5. Push the slider against the inhibitor wall.

      Note


      • Do not pull up the slider.

      • When adjusting the cable, make sure that the shift lever is not in 1 or 2.

    6. Lock the cable length adjustment structure of the select cable.


      1. Turn the stopper.*1

      2. Push the lock piece into the case.*2

      3. Return the stopper to prevent the lock from being released.*3

        Note


        • Push the lock piece as far as it will go.

        • Confirm whether the cable length adjustment structure is locked securely.

    7. A01IS1EE01

      Move the shift lever to R to release the outer lever.