CLUTCH UNIT (for 1AD-FTV, 2AD-FHV) INSPECTION


  1. INSPECT CLUTCH DISC ASSEMBLY


    1. A01IRYY

      Using a vernier caliper, measure the rivet head depth.

      Minimum rivet depth
      0.3 mm (0.0118 in.)

      If the depth is less than the minimum, replace the clutch disc assembly.

    2. A01INYJE01

      Install the clutch disc onto the manual transaxle assembly.

      Note

      Insert the clutch disc assembly with the disc facing the correct direction.

    3. Using a dial indicator with a roller instrument, measure the clutch disc runout.

      Maximum runout
      0.8 mm (0.0315 in.)

      If the runout is more than the maximum, replace the clutch disc assembly.

  2. INSPECT CLUTCH COVER ASSEMBLY


    1. A01IO1QE01

      Using a vernier caliper, measure the diaphragm spring for the depth and width of wear.

      Maximum
      A (Depth)
      0.5 mm (0.0197 in.)
      B (Width)
      6.0 mm (0.236 in.)

      If the depth or width is more than the maximum, replace the clutch cover assembly.

  3. INSPECT FLYWHEEL SUB-ASSEMBLY


    1. A01IQ22

      Using a dial indicator with a roller instrument, measure the flywheel runout.

      Maximum runout
      0.1 mm (0.00394 in.)

      If the runout is more than the maximum, replace the flywheel sub-assembly.

  4. INSPECT CLUTCH RELEASE BEARING ASSEMBLY

    A01ISYCE01

    1. Check that the clutch release bearing assembly moves smoothly without abnormal resistance by turning the sliding parts of the clutch release bearing assembly (contact surfaces with the clutch cover) while applying force in the axial direction.

    2. Inspect the clutch release bearing assembly for damage and wear.

      If necessary, replace the clutch release bearing assembly.