| DTC Code | DTC Name |
|---|---|
| P2716 | Pressure Control Solenoid "D" Electrical (Shift Solenoid Valve SLT) |
DESCRIPTION
Refer to DTC P2714 (Click here).
| DTC Code | DTC Detection Condition | Trouble Area |
|---|---|---|
| P2716 | Open or short is detected in shift solenoid valve SLT circuit for 1 second or more while driving (1-trip detection logic). |
|
MONITOR DESCRIPTION
When an open or short in the shift solenoid valve SLT circuit is detected, the TCM interprets this as a fault. The TCM will turn on the MIL and store the DTC.
INSPECTION PROCEDURE
PROCEDURE
- Click here
INSPECT TRANSMISSION WIRE (SHIFT SOLENOID VALVE SLT)
-
Remove the TCM.
-
Measure the resistance according to the value(s) in the table below.
Standard Resistance Tester Connection Condition Specified Condition 12 (SLT+) - 7 (SLT-) 20°C (68°F) 5.0 to 5.6 Ω 12 (SLT+) - Body ground Always 10 kΩ or higher 7 (SLT-) - Body ground Always 10 kΩ or higher 12 (SLT+) - All other terminals except 7 (SLT-) Always 10 kΩ or higher 7 (SLT-) - All other terminals except 12 (SLT+) Always 10 kΩ or higher Table 1. Text in Illustration *a Component without TCM connected
(Transmission Wire)
- OKClick here
- NGClick here
-
- Click here
REPLACE TCMClick here
- Click here
INSPECT SHIFT SOLENOID VALVE SLT
-
Remove shift solenoid valve SLT.
-
Measure the resistance according to the value(s) in the table below.
Standard Resistance Tester Connection Condition Specified Condition 1 - 2 20°C (68°F) 5.0 to 5.6 Ω -
Apply 12 V battery voltage to the shift solenoid valve and check that the valve moves and makes an operating noise.
OK Measurement Condition Specified Condition
-
Battery positive (+) with a 21 W bulb → Terminal 1
-
Battery negative (-) → Terminal 2
Valve moves and makes an operating noise Table 2. Text in Illustration *a Component without harness connected
(Shift Solenoid Valve SLT)
-
- OKClick here
- NGClick here
-
- Click here
REPLACE TRANSMISSION WIREClick here
- Click here
REPLACE SHIFT SOLENOID VALVE SLTClick here