ENGINE STOP AND START ECU REMOVAL


  1. READ NUMBER OF STARTER OPERATIONS

    Click here

  2. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

  3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  4. REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

    A01IO1E

    1. Detach the 3 claws and guide, and remove the No. 2 instrument panel under cover.

  5. REMOVE GLOVE COMPARTMENT DOOR ASSEMBLY

    A01IP4S

    1. Push in the sides of the glove compartment door to release the 2 stoppers and open the glove compartment door until it is horizontal.

    2. Detach the glove compartment door stopper from the glove compartment door as shown in the illustration.

    3. A01IP3S

      Pull the glove compartment door toward the rear of the vehicle to detach the 2 hinges and remove the glove compartment door.

  6. REMOVE ECU INTEGRATION BOX RH (for LHD)

    A01INKM

    1. Disconnect the 9 connectors and clamp.

    2. Remove the 2 nuts, bolt and ECU integration box RH.

  7. REMOVE ENGINE STOP AND START ECU (for LHD)

    A01IQP7

    1. Disengage the 2 claws to remove the engine stop and start ECU from the ECU integration box RH.

  8. REMOVE ENGINE STOP AND START ECU (for RHD)


    1. A01IO5F

      Remove the screw and disconnect the connector holder.

    2. A01IT8W

      Disconnect the 3 connectors from the engine stop and start ECU.

    3. Remove the 2 bolts and engine stop and start ECU.