Click here

CRUISE CONTROL MAIN SWITCH REMOVAL

Click here
Click here Click here
Tip:

  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.

Click here
  1. Click here

    PRECAUTION

    Note:

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).

  2. Click here

    DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    Note:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).

  3. Click here

    REMOVE STEERING PAD


    1. A01IQYJ

      Using a screwdriver, detach the 2 springs.

    2. A01INT0

      Pull out the steering pad from the steering wheel as shown in the illustration and support the steering pad with one hand.

      Note:

      When removing the steering pad, do not pull the airbag wire harness.

    3. Disconnect the horn connector.

    4. Disconnect the connector and remove the steering pad.

      Note:

      When handling the airbag connector, take care not to damage the airbag wire harness.

  4. Click here

    REMOVE CRUISE CONTROL MAIN SWITCH ASSEMBLY


    1. A01INYPE01

      Put protective tape around the switch.

      Table 1. Text in Illustration
      *1 Protective Tape
    2. A01ITOEE01

      Disconnect the connector.

      Table 2. Text in Illustration
      *1 Protective Tape

    3. Remove the 2 screws and switch.