CRUISE CONTROL MAIN SWITCH REMOVAL

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.


  1. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

  2. REMOVE BATTERY SERVICE HOLE COVER


    1. A01ITOM

      Remove the clip and battery service hole cover.

  3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  4. REMOVE STEERING PAD


    1. A01IQYJ

      Using a screwdriver, detach the 2 springs.

    2. A01INT0

      Pull out the steering pad from the steering wheel as shown in the illustration and support the steering pad with one hand.

      Note

      When removing the steering pad, do not pull the airbag wire harness.

    3. Disconnect the horn connector.

    4. Disconnect the connector and remove the steering pad.

      Note

      When handling the airbag connector, take care not to damage the airbag wire harness.

  5. REMOVE CRUISE CONTROL MAIN SWITCH ASSEMBLY


    1. A01INYPE01
      Text in Illustration
      *1 Protective Tape

      Put protective tape around the switch.

    2. A01ITOEE01
      Text in Illustration
      *1 Protective Tape

      Disconnect the connector.

    3. Remove the 2 screws and switch.